Removal & Disassembly of the Power Window Regulator Assembly
REMOVAL OF POWER WINDOW REGULATOR ASSEMBLYRemove the regulator assembly according to the applicable service manual.
^ 1985 Subaru XT service manual section 5-2 page 12
^ 1986 Subaru XT service manual section 5-2 page 27
^ 1987 Subaru XT service manual section 5-2 page 12
^ 1988 Subaru XT service manual section 5-2 page 12
DISASSEMBLY OF THE REGULATOR ASSEMBLY
1. Using a phillips screwdriver remove the three retaining screws which hold the regulator motor in place and remove the motor.
FIGURE 1:
2. Slowly move the sliding section up to the top of the slide rail and remove the lower corner clip using a standard screwdriver. See Figure 1.
FIGURE 2:
3. Remove the inner lock holder by pushing the retaining clips inward with a standard screw driver. See Figure 2.
FIGURE 3:
4. Remove the upper corner clip and then the entire cable assembly from the slide rail. See Figure 3