Removal and Replacement

Distributor:

REMOVAL
1. Remove wires from distributor cap and remove cap.
2. Disconnect primary wire.
3. Remove distributor retaining bolt and remove distributor.
4. Remove O-ring.

INSTALLATION
1. Install O-ring onto distributor housing.
2. Lube distributor housing LIGHTLY with anti-seize compound.
3. Install distributor into cylinder and turn rotor to align.

NOTE: Distributor and cam are keyed. Distributor can only be inserted one way.

4. Install hold down screw and tighten slightly.
5. Install distributor cap and wires.
6. Connect electrical connector.
7. Adjust timing.