Restraint Systems

CAUTION:

Before troubleshooting airbag system, disconnect battery ground cable, turn ignition switch "OFF" and then wait at least 10 minutes.

1. AIRBAG MAIN HARNESS INSPECTION

1) Remove lower cover and panel (Refer to 5-4 [W2OO].>, and connect connector (AB8) at harness spool to test harness-C connector (1C).

2) Disconnect connector (ABG) (Refer to [WOC2].) from airbag control unit, and connect it to test harness-B connector (8B) terminal.

3) Measure resistance between test harness-B connector (5B) and test harness-C connector (3C) terminals.

Connector & terminal / Specified resistance:

(5B) No.14 - (3C) No.2 /10 ~ max.
(5B) No.1 - (3C) No.6 /10 ~ max.
5-5-36----------------






2. ROLL CONNECTOR INSPECTION

1) Remove airbag module and place it with pad side facing upward.



2) Connect roll connector (AB7) to test harness-C connector (1C).

3) Connect connector (AB3) at harness spool to test harness-C connector (2C).

4) Measure resistance between test harness-C connector (3C) terminals.

(3C) Terminals / Specified resistance:

No.1 - No.5 / 10 ~ max.

No.2 - No.4 /10 ~ max.

No.3 - No.6 /10 ~ max.
5-5-37----------