A/T, M/T - Crossmember Service Precautions
NUMBER: 03-53-04, 16-54-04DATE: 08/20/04
APPLICABILITY:
All A/T and M/T Vehicles
SUBJECT:
Transmission Rear Cross-Member
INTRODUCTION
The purpose of this bulletin is to prevent the possibility of damaging the bolts and/or threads that secure the transmission rear cross member.
REPAIR PROCEDURES/INFORMATION
When performing service work or installing SOA's accessory short throw shifter, it is extremely important that the transmission is supported properly when removing or reinstalling the cross member. If not, damage to the bolts and/or threads will occur. Support the transmission using a transmission jack, regardless if the vehicle is supported by a lift or car ramps (Figure 1). It is recommended that hand tools be used for the removal and installation of the bolts. Inspect for bolt thread damage and replace as necessary. Be sure to clean any protective wax from the mating surfaces and be sure to start all bolts several threads by hand before using tightening tools. Note: If severe damage is evident to the threads, the use of a Heli-coil(R) type kit is an approved repair method.
During reinstallation torque sequence, below (Figure 2) and the torque specifications (Figure 3)
Bolts must be torqued to the proper specifications (Figure 3).