Fuel Filter: Service and Repair
PRELIMINARY PROCEDURESRelease fuel pressure. Fuel Pressure Release
REMOVAL
Fuel Filter:
1. Loosen screws on filter clamps.
2. Twist and pull the hoses to remove filter.
INSPECTION
1. Inspect filter for dirt or water sediment.
2. If filter is clogged or cracked, or if replacement interval has been reached, replace filter.
3. If water is found in filter, shake filter with inlet facing down to expel water (inspection of the fuel tank is advised).
INSTALLATION
Fuel Hose Clamp Installation:
1. Inspect hoses for cracks or damage. Replace if necessary.
2. Inspect clamps for deformation or damage. Replace if necessary.
3. Connect hoses as illustrated.
4. Tighten hose clamps.
HOSE CLAMP TORQUE VALUE
1.0-1.5 Nm (0.7-1.1 ft.lbs.)
5. Place filter in bracket, making sure hoses are not twisted or kinked.
6. Connect fuel pump connector and reinstall access cover and carpet.
7. Start engine and assure there are no leaks.