Heater - Vent Door Binding Or Leaking Air
NUMBER: 10-64-93DATE: 11-08-93
APPLICABILITY: 93MY IMPREZA
SUBJECT:
HEATER VENT DOOR BINDING OR LEAKING AIR
If air is found coming out of the center vent while the mode selector is in the heat position or the vent door is found to be binding, the center duct may be deformed.
To correct this condition, install a clip/bracket in the left side opening of the center vent. This part can be obtained through the Technical Service Helpline.
1. Remove the two (2) Phillips screws from the bottom of the center vent grill.
2. Pull the center vent out, being careful not to break the two (2) lock tabs on each side.
3. Slide the small curved end of the clip over the outer edge of the left duct, then snap it into place on the inner side.
Then slide it towards the right side of the left duct, as illustrated.
Check operation of the vent door and reassemble in reverse order.