DTC 02

DIAGNOSIS:
- Front sensor harness is shorted.
- Airbag main harness is shorted.
- Airbag module harness is shorted.
- Roll connector is shorted.
- Airbag control module is faulty.

CAUTION: Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground terminal and then wait at least 20 seconds.
After 20 seconds elapse, remove instrument panel lower cover, and disconnect (AB3) and (AB8).




1. FRONT SENSOR AND HARNESS INSPECTION
1. Disconnect connectors (AB4) and (AB5) from airbag control module.
2. Connect connectors (AB4) and (AB5) to connector (8B) of test harness B.
3. Measure resistance between connector (5B) terminals indicated below.

(5B) Terminals / Specified resistance:
(RH: AB4): No.17 - No.18 / 1.4 - 1.6 kOhm
(LH: AB5): No.15 - No.16 / 1.4 - 1.6 kOhm

4. Measure resistance between each connector (5B) terminal and body.

(5B) Terminals / Specified resistance:
(RH: AB4): No.17 - Body / 200 Ohm, or more
No.18 - Body / 200 Ohm, or more
(LH: AB5): No.15 - Body / 200 Ohm, or more
No.16 - Body / 200 Ohm, or more




2. AIRBAG MAIN HARNESS INSPECTION
1. Disconnect connector (AB6) from airbag control module, and connect (AB6) to test harness-B connector (8B).
2. Measure resistance between each (5B) terminal and body.

(5B) Terminals / Specified resistance:
No.1 - Body / 200 Ohm, or more
No.14 - Body / 200 Ohm, or more