DTC 35

DIAGNOSIS:
- The purge control solenoid valve is not in function.
- The harness connector between ECM and purge control solenoid valve is in short or open.

TROUBLE SYMPTOM:
- Erroneous idling




1. CHECK INPUT SIGNAL FOR ECM.
1. Turn ignition switch to ON.
2. Measure voltage between ECM connector terminal and body.

Connector & terminal / Specified voltage:
(E30) No.19 - Body / 10 - 13 V

2. CHECK PURGE CONTROL SOLENOID VALVE.
1. Turn ignition switch to OFF.
2. Remove purge control solenoid valve.
3. Measure resistance between solenoid valve Terminals.

Terminals / Specified resistance:
No.1 - No.2 / 36 Ohm [at 20 °C (68 °F)]




3. CHECK POWER SUPPLY TO PURGE CONTROL SOLENOID VALVE.
1. Turn ignition switch to ON.
2. Measure voltage between purge control solenoid valve connector and body.

Connector & terminal / Specified voltage:
(E6) No.1 - Body / 10 V, min.