Fuel Filter: Testing and Inspection
RELEASE FUEL PRESSURE1. Remove fuel pump fuse.
2. Start the engine and run it until it stalls.
3. After the engine stalls, crank it for five (5) more seconds.
4. Turn the key "OFF".
5. Reinstall fuel pump fuse.
REMOVAL
Fuel Filter Fasteners:
1. Remove fuel filter fasteners.
2. Using needle-nose locking pliers to clamp fuel delivery hose (to prevent fuel spilage).
3. Remove hose clamps and hoses.
4. Remove filter.
INSPECTION
1. Inspect filter for dirt or water sediment.
2. If filter is clogged or cracked, or if replacement interval has been reached, replace filter.
3. If water is found in filter, shake filter with inlet facing down to expel water (inspection of the fuel tank is advised).
INSTALLATION
1. Inspect hoses for cracks or damage. Replace if necessary.
2. Inspect clamps for deformation or damage. Replace if necessary.
3. Tighten hose clamps to 1.0 - 1.5 Nm (0.7 - 1.1 ft lb).
4. Place filter in bracket, making sure hoses are not twisted or kinked.
5. Install bracket fasteners.
6. Start engine and assure there are no leaks.