Spark Plug: Service and Repair
REMOVAL1. Twist and pull to remove ignition wire from plug.
2. While wearing saftey glases, use compressed air to blow out debris from plug well.
3. Using a 5/8" (16mm) socket, remove plug.
INSTALLATION
1. Adjust electrode gap to 0.039 - 0.043 in (1.0 - 1.1 mm).
2. Lightly coat threads of plug with anti-seize compound.
3. Install and thread plug into cylinder head by hand.
4. Torque spark plug to 13 - 17 ft.lb (18 - 24 Nm).
5. Apply dielectric compound to the inside of ignition wire boot and install. A slight click will be heard when wire is properly connected.
RECOMMENDED SPARK PLUGS
BRAND PART NO.
---------------------------------
NGK BPR6ES-11
NIPPONDENSO W20EPR-U11
CHAMPION RC9YC-4