Clutch Seizure/Failure, SVX & Legacy Turbo Bulletin 16-58-94

Be advised that P/N 31541AA030 (High Clutch Drum) should be changed to read P/N 31541AA020. (Refer to item number 3 "High Clutch Seizure/Failure", SVX and Legacy Turbo of Service Bulletin 16-58-94.

Also, when installing the new style High Clutch Hub, P/N 31550AA020, into an older style front sun gear with the bushing installed, the hub will not pass through the sun gear. It is necessary to remove the bushing from the sun gear. This is a simple procedure and can be accomplished using a small punch. A NEW STYLE FRONT SUN GEAR IS NOT NECESSARY.

When installing Thrust Bearing, P/N 806537010, it is necessary to install two bearings, one bearing is installed between the high clutch hub and the front sun gear, the other between the high clutch hub and high clutch drum. These bearings must be installed correctly. The smaller inner bearing race must face the front of the transmission.

If you have any questions concerning this matter, contact the Technical Helpline. A Service Bulletin will be released concerning this information.