93MY Impreza Air Conditioning Inoperative

After verifying that the system has an adequate charge of R-12 using a manifold gauge set and jumping the compressor to engage it, check the mode control panel. If an open circuit is found, the problem may be a poor connection at connector F-33 to I-6.

LOYALE FACTORY INSTALLED A/C DOES NOT OPERATE

We have received reports of connector F66 (a black 21 pin connector located behind the fuse box) being partially unplugged. This connector has wiring for the pulser system and various A/C components, including the mode switch. Always check the basics; fuses, connectors and pressures.

SVX AUTO A/C DISPLAY DEGREES CELSIUS TO DEGREES FAHRENHEIT

During PDI and if you receive a customer complaint of the temperature display reading in Celsius not Fahrenheit, perform the following:

^ Locate the single pin connector B-33 in the left kick panel.
Tip: Connector B-33 is next to the PDI shorting loop for lean run.

^ Connector B-33 must be connected for the display to read in degrees Fahrenheit; disconnected, the display reads degrees Celsius.