Installation

Caution: Before or during assembly, lubricate the following points with a light coat of grease:
a) Inner groove of release bearing
b) Contact surface of lever and pivot
c) Contact surface of lever and bearing
d) Transmission main shaft spline - Use grease containing molybdenum disulfide.

1. Install retainer spring into lever.
2. While pushing lever to pivot and twisting it to both sides, fit retainer spring onto the constricted portion of pivot. Confirm that the retainer spring is securely fitted by observing it through the main case hole.
3. Install release bearing and fasten it with two clips.
4. Install release lever seal.
5. After remounting engine and transmission on body, make adjustment of the clutch release lever end play. Take care not to twist the cable during adjustment.
6. Install release lever return spring. Hook up the long hook side of the return spring with the lever.