Removal and Installation

1. BLADE




Pull out blade following the arrow direction, from arm while pushing up locking clip.

2. WIPER ARM




1. Remove head cover.
2. Remove nut and wiper arm.

Tightening torque:
5.9 ± 1.5 N.m (0.6 ± 0.15 kg-m, 4.3 ± 1.1 ft-lb)

3. WIPER MOTOR




1. Remove cap and special nut.

CAUTION: Be careful not to strike service tool against nozzle during removal.

Tightening torque:
7.4 ± 1.5 N.m (0.75 ± 0.15 kg-m, 5.4 ± 1.1 ft-lb)

2. Remove rear gate trim.
3. Undo clips which secure harness, and disconnect connector of wiper motor.




4. Separate washer hoses at joint.
5. Remove attaching screws and take out wiper motor assembly.

CAUTION: Be careful not 10 damage O-ring when removing wiper motor assembly.

Tightening torque:
5.9 ± 1.5 N.m (0.6 ± 0.15 kg-m, 4.3 ± 1.1 ft-lb)

4. WASHER TANK AND WASHER MOTOR
Refer to removal and installation of washer tank and washer motor.

5. COMBINATION SWITCH
Refer to removal and installation of combination switch.