Tail Lamp: Testing and Inspection

1. STOP LIGHT SWITCH (ON-CAR)

Without cruise control model







1. Disconnect connector of stop light switch from body harness.
2. Check continuity between terminals when push rod is pushed in 4.0 to 4.5 mm (0.157 to 0.177 in) from end of outer case.

With cruise control model







1. Disconnect connector of stop light switch from body harness.
2. Check continuity between terminals when push rod is pushed in 1.5 to 3.0 mm (0.059 to 0.118 in) from end of outer case.

With TCS model







1. Disconnect connector of stop light switch from body harness.
2. Check continuity between terminals when push rod is pushed in 1.2 to 3.2 mm (0.047 to 0.126 in) from end of outer case.

2. COMBINATION SWITCH (ON-CAR)
Refer to inspection of combination switch.







3. TAIL AND ILLUMINATION RELAY
Check continuity between terminals as indicated in table, when connecting battery to terminal No.1 and No.3