Rear Bumper: Service and Repair

Rear Bumper

REMOVAL

1. SEDAN




1. Open trunk lid. Remove trunk trim panel clips and detach trim.
2. Disconnect license plate light connector.
3. Remove bolts from side of bumper.




4. Remove bolts from bumper stay.




5. Remove rear bumper.

2. WAGON
1. Open rear gate and rear quarter trim lid.
2. Disconnect license plate light connector.
3. Remove bolts from side of bumper.
4. Remove bolts from bumper stays.
5. Remove bumper assembly.




INSTALLATION
To install the rear bumper, reverse the above removal procedures.

CAUTION:
- Be extremely careful to prevent scratches on bumper face as it is made of resin.
- Be careful not to scratch the body when removing or installing bumper.
- To facilitate installation of rear bumper, attach hook (located at stay) to body panel.