Fender: Service and Repair

Front Fender

REMOVAL

SUPPLEMENTAL RESTRAINT SYSTEM "AIRBAG"
Airbag system wiring harness is routed near the front fender.

CAUTION:
- All Airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuit.
- Be careful not to damage Airbag system wiring harness when servicing the front fender.







1. Disconnect ground cable from battery.
2. Remove mud guard.
3. Remove parking light and headlight.
4. Remove front bumper.
5. Remove bolts which secure fender to radiator panel and turn signal light connector.
6. Remove body protector. (This step may be skipped if fender is to be reused.)
7. Remove attaching bolt to remove fender.

CAUTION: Be careful not to scratch body panels with fender edges when removing it.

INSTALLATION







1. Installation is in the reverse order of removal.
2. Check for alignment of front fender with hood and front door with front fender at all points. Adjust, if necessary.