Check Indicator and Circuit In Cruise Control Main Switch

Diagnostics Chart For Power Line

CHECK INDICATOR AND CIRCUIT IN CRUISE CONTROL MAIN SWITCH




DIAGNOSIS:
- Bulb failure or open harness of the indicator circuit in the cruise control main switch.

TROUBLE SYMPTOM:
- Cruise control can be set, normally indicator does not come on. (When main switch is pressed.)




1. CRUISE CONTROL MAIN SWITCH
1. Remove cruise main switch.
Turn lower part of the housing upward to remove. If this cannot be done, insert a small screwdriver on the right hand side of the housing to remove the lock.

2. Measure resistance value between cruise control main switch terminals.

Terminal / Specified resistance:
No.1 - No. 6 / Approx. 120 Ohm




2. CHECK CIRCUIT BETWEEN CRUISE CONTROL MODULE AND CRUISE CONTROL MAIN SWITCH INDICATOR LIGHT
1. Measure voltage between cruise control main switch and body. (Perform this measurement by turning ON the ignition switch and the cruise control main switch.)

Connector & terminal / Specified voltage:
(i10) No.1 - Body / 10 - 13 V

2. Remove the connector from the cruise control main switch.
3. Measure the resistance value between the cruise control main switch connector and the body.

Connector & terminal / Specified resistance:
(i10) No.6 - Body / 10 Ohm, max.