Removal and Installation

REMOVAL AND INSTALLATION

1. HEADLIGHT AND FRONT TURN SIGNAL LIGHT

1. Remove front grille and disconnect connector from headlight.
2. Remove screws which secure front turn signal light.
3. Remove front turn signal light while disconnecting connector.

NOTE: When installing, securely fit clip (on fender side) into locating (on front turn signal light side).




4. Remove screws and bolts which secure headlight and remove headlight.

Tightening torque: 6 - 7 N.m (0.6 - 0.7 kg.m, 4.3 - 5.1 ft.lb)




2. REAR COMBINATION LIGHT

1. Remove rear trim.
2. Remove nuts and disconnect connector.

Tightening torque: 6 - 7 N.m (0.6 - 0.7 kg.m, 4.3 - 5.1 ft.lb)

3. Attach adhesive cloth tape to body area around rear combination light.
4. Using a standard screwdriver, carefully pry rear combination light off and away from the front of vehicle.

CAUTION:
- Do not pry rear combination light forcefully as this may scratch vehicle body.
- Remove all traces of adhesive tape from body before installation.
- Attach butyl rubber tape to back of rear combination light before installing rear combination light on body for sealing purposes.

3. COMBINATION SWITCH (WITHOUT AIRBAG MODEL)

Refer to Combination Switch as for removal of combination switch on airbag equipped model.




1. Remove steering wheel.
2. Remove screws which secure upper column cover to lower column cover.
3. Remove screws which secure knee protector and remove knee protector.

CAUTION: When installing knee protector, ensure that harness is not caught by adjacent parts.

4. Disconnect connector from body harness and undo holddown band.




5. Remove screws which secure switch and remove switch.

CAUTION:
During installation (with key interlock)
- When routing combination switch harness around steering system, do not place it over key interlock release knob.
- After installing lower column cover, ensure that key interlock release knob is accessible.