Accelerator Pedal: Service and Repair

REMOVAL
1) Disconnect accelerator cable from connector inside engine compartment first.





2) Remove lock nul from accelerator cable bracket.
3) Separate accelerator cable from bracket, then unlock inner cable.
4) Remove cable end from throttle cam using your fingertips.

CAUTION: Be careful not to bend inner cable.

5) Disconnect cable end from accelerator cable bracket inside driver compartment.
6) Remove clip inside engine compartment.





7) Working inside engine compartment, remove cable connection by turning toe board clockwise.

INSTALLATION
1) Pass inner cable through toe board hole and route inside driver compartment. Install cable bushing on accelerator pedal end.
2) While turning accelerator cable counterclockwise, transfer it to driver compartment through toe board hole.
3) Connect accelerator cable to upper holder of accelerator pedal.
4) Install clip inside engine compartment.
5) To install cable to throttle cam, reverse the order of the removal procedures.

Tightening torque:
14 ± 4 Nm (1.4 ± 0.4 kg-m, 10.1 ± 2.9 ft-Ib.)

6) Adjustment after cable installation.