Air Bag: Service Precautions

Precaution

AIRBAG MODULE




1. The airbag module must not be disassembled. The airbag module cannot be used again once inflated.




2. When removing and installing the airbag module, the operator should stand, as much as possible, on the side of the airbag module.




3. After removal, the airbag module should be kept away from heat and light sources, and stored on a clean, flat surface to prevent from any damage to its lower structure.




4. Do not check airbag module continuity with airbag removed from the vehicle body.

Part 1:

Part 2:

5. Replace airbag module with a new one, should any of the following conditions develop.
- Pad surface is scratched or cracked.
- Connector harness is damaged.
- Inflator side structure of module is cracked or deformed.
- Module is excessively stained with water, oil, etc.
- Module was accidentally dropped.

6. When storing a removed airbag module, be sure to place it in parallel with floor with the pad facing up. Do not place it against a wall, or place anything on the pad; otherwise, a dangerous condition may be created if the module malfunctions.