Rear Door Window Glass: Service and Repair

REMOVAL




1. Remove roof molding.
2. Remove rear window molding upper and lower.
3. Disconnect connector from rear defogger terminal.
4. Remove glass in same manner as in windshield.






NOTE: A matching pin is cemented to the corners of glass on compartment side. Use a piano wire when cutting each pin.

INSTALLATION




1. Install glass in same manner as in windshield.
2. Firstly, press-fit molding upper, then lower and lastly, roof molding.
3. After installation, test for water leakage after about one hour, and leave vehicle alone for 24 hours.
4. Make rear defogger connections.