Hood: Service and Repair

REMOVAL




1. HOOD
1. Open front hood, and remove attaching bolt.
2. Detach front hood from hinges.




2. HOOD LOCK
1. Open front hood and remove front grille.
2. Remove bolts which secure lock assembly to radiator panel, and remove lock assembly.
3. Disconnect release cable from lock assembly.




3. RELEASE CABLE
1. Remove front grille.
2. Remove release cable from lock assembly.
3. Remove cable clip from engine compartment.
4. Remove bracket from front pillar.







INSTALLATION
Installation is in the reverse order of removal.

CAUTION: Adjust buffer assembly on each end so that main lock is applied securely when hood is released from a height of approx. 20 mm (0.79 in).

NOTE:
- Align the center of striker with lock during installation. Make sure safety lever is properly caught by striker under the hood's own weight.
- Route hood lock release cable and hold with clips.
- After installing release cable, ensure it operates smoothly.
- Apply grease to sliding surfaces of parts.