Rear Wiper and Washer

REMOVAL AND INSTALLATION




1. BLADE
Pull out blade from arm while pushing up clip.




2. WIPER ARM
1. Remove head cover.
2. Remove nut and wiper arm.

Tightening torque:
4.4 - 7.4 N.m (0.45 - 0.75 kg.m, 3.3 - 5.4 ft.lb)

3. WIPER MOTOR




1. Remove cap and special nut.

CAUTION: Be careful not to strike service tool against nozzle during removal.

Tightening torque:
6 - 9 N.m (0.6 - 0.9 kg.m, 4.3 - 6.5 ft.lb)

2. Remove rear gate trim.
3. Undo clips which secure harness, and disconnect connector.




4. Separate washer hoses at joint.
5. Remove attaching screws and take out wiper motor assembly.

CAUTION: Be careful not to damage O-ring when removing wiper motor assembly.

Tightening torque:
4.4 - 7.4 N.m (0.45 - 0.75 kg.m, 3.3 - 5.4 ft.lb)

4. WASHER TANK
1. Remove rear quarter trim.




2. Disconnect washer hose and connector.
3. Remove attaching bolts.

Tightening torque:
4.4 - 7.4 N.m (0.45 - 0.75 kg.m, 3.3 - 5.4 ft.lb)