Rear Wiper and Washer

1. COMBINATION SWITCH (ON-CAR)
1. Remove instrument panel lower cover.
2. Remove lower column cover.
3. Unfasten holddown clip which secures harness, and disconnect connectors from body harness.







4. Set rear wiper and washer switch to each position and check continuity between terminals as indicated in table.

2. WIPER MOTOR




1. Operational check
Connect battery to wiper motor and check operation of wiper motor.




2. Check wiper motor for proper stoppage.
After operating wiper motor, disconnect battery from wiper motor.




3. Reconnect battery and ensure that wiper motor stops at "AUTO STOP" after it has been operated.

3. REAR WIPER RELAY
1. Connect battery to terminal No.1 and ground terminal No.2.







2. Check continuity between terminals as indicated in table:




4. WASHER MOTOR
Apply battery voltage between terminals of washer motor connector and check that washer motor operates.