Separation of Transmission

1. SEPARATION OF TRANSMISSION





1) Remove clutch release lever (1) and bearing (2).





2) Remove bearing mounting bolts.





3) Remove main shaft rear plate (4).





4) Separating transmission case
(1) Put vinyl tape around spines of right and left axle drive shafts to prevent damage to oil seals.





(2) Separate transmission case into right and left cases by loosening seventeen coupling bolts and nuts.





5) Remove drive pinion shaft assembly (6) from left side transmission case.

NOTE: Use a hammer handle, etc. to remove if too tight.

6) Remove main shaft assembly (7).





7) Remove differential assembly.

CAUTION:
- Be careful not to confuse right and left roller bearing outer races.
- Be careful not to damage retainer oil seal.