A: Disassembly

A: DISASSEMBLY
1) Remove snap ring (1) (Inner-lb) using flat bladed screwdriver.
2) Remove center differential cover (2).
3) Remove snap ring (4) and roller bearing (3).
4) Remove viscous coupling (5).
5) Remove needle bearings (6).
6) Remove adjusting washer (7) (45 x 62 x t).
7) Remove pinion shaft (8), bevel pinions (9) and retainers (10).
8) Remove side gear (11).
9) Remove thrust washer (12).





10) Remove ball bearing (13) using ST. ST 498077300 CENTER DIFFERENTIAL BEARING REMOVER

CAUTION: Do not reuse ball bearing.