Disassembly and Assembly

DISASSEMBLY
1. Remove the grip from the selector lever CP.





(1) Remove the screw to take off the grip from the selector lever CP.





2. Remove the indicator cover from the elate.





3. Remove the following parts from the grip.
(1) Grip button
(2) Spring





4. Remove the shift lock release button from the indicator cover.





5. Remove the solenoid.





6. Remove the screw to take off the "P" position switch CP.





7. Remove the bolt to take off the selector lever CP from the orate.
8. Remove the lock plate.





9. Remove the selector lever CP from the plate.

INSPECTION
1. Inspect the removed parts by comparing with new ones for deformation, damage and wear. Correct or replace if defective.
2. Confirm the following parts for operating condition before assembly.
(1) Sliding condition of the grip button in the grip ... it should move smoothly.
(2) Insertion of the grip on the selector lever ... when pushing the grip on the selector lever by hand, the screw holes should be aligned.
(3) Operation of the selector lever and rod ... they should move smoothly.
(4) Insertion of the spacer into the selector lever ... it should be inserted lightly by finger pressure.

ASSEMBLY
1. Clean all parts before assembly.
2. Assemble the selector lever CP and the lock plate to the plate.





3. Insert the bolt and tighten the flange nut to the specified torque.
Tightening torque (Flange nut): 11-17 Nm (8-12 ft lbs.)

4. Assemble the solenoid.





5. Adjust the position of the solenoid.
6. Make sure you tighten the bolts when installing the solenoid.
7. Assemble the "P" position switch CP to the plate.
8. Assemble the shift lock release button to the indicator cover.





9. Assemble the indicator cover to the plate.
Tightening torque: 1.3-2.6 Nm (11-24 in.lb)





10. Assemble the following parts to the grip.
Apply grease on the sliding surfaces.





11. Assemble the grip to the selector lever CP.





12. Route bulb, solenoid and switch harnesses as shown.
13. After the completion of fitting, transfer the selector lever to range "P"-"1", pressing the grip button of the grip; then check whether the indicator and select lever agree, whether the pointer and position mark agree and what the operating force is.