Torque Converter Clutch Case Section

1. Wrap the axle shaft serration with vinyl tape.
2. Remove the differential side retainer with Special Tool (ST).

ST 499787000 Wrench Assy, or equivalent.

CAUTION: Hold the differential case assembly by hand to avoid damaging retainer mounting hole of the torque converter clutch case and speedometer gears.





3. Extract the axle shaft with ST1 and ST2.

ST1 499095500 Remover, or equivalent.
ST2 499247300 Installer, or equivalent.

CAUTION: Do not reuse the circlip.





4. Remove the differential case assembly.

CAUTION:
- Remove the seal pipe if it is attached. (Reusing is not allowed.)
- Be careful not to damage the retainer mounting hole of the torque converter clutch case and the speedometer gears.





5. Remove the snap ring Then remove the speedometer driven gear.





6. Tap out the speedometer shaft to the outside of the case, and remove the oil seal.