Control Valve and Oil Pan

1. Install four accumulators with oil pans facing upward.





CAUTION: Be careful not to confuse the springs and installation





2. Install and route the transmission harness.

CAUTION: Be careful not to damage the harness.

3. Install the control valve assembly.
a. Set the select lever in range "2".





b. Install the two brackets, ATF temperature sensor and the control valve by engaging the manual valve and manual lever, then tighten the 17 bolts.

Tightening torque: 8 +/- 1 Nm (69.6 +/- 8 inch lbs.).

CAUTION:
^ Be careful not to pinch the harness roll the gasket.
^ Tighten the control valve mounting bolts evenly.





4. Install the oil strainer to the control valve. Be careful not to cut or break the O-ring. Then tighten four bolts.

Tightening torque: 8 +/- 1 Nm (69.6 +/- 8 inch lbs.).





5. Secure four connectors.





6. Install the oil cooler outlet pipe, and secure with two bolts.

Tightening torque: 8 +/- 1 Nm (69.6 +/- 8 inch lbs.).

CAUTION: Fit the pipe into position. Be careful to avoid twisting.

7. Install the oil pan.





a. Attach the magnet at the specified position.





b. Apply proper amount of liquid gasket (THREE BOND Part No. 1217B) to the entire oil pan mating surface.





c. Install the oil pan to transmission case.

Tightening torque: 4.9 +/- 0.5 Nm (43 +/- 5 inch lbs.).

NOTE: Tighten the bolts evenly.