Flywheel: Testing and Inspection

CAUTION: Since this bearing is grease sealed and is of a nonlubrication type, do not wash with gasoline or any solvent.





1. Damage of facing and ring gear If defective, replace flywheel.





2. Smoothness of rotation.
Rotate ball bearing applying pressure in thrust direction.

If noise or excessive play is noted, replace ball bearing as follows:

(1) Drive out ball bearing from flywheel.
(2) Press bearing into flywheel until bearing end surface is flush with clutch disc contact surface of flywheel. Do not press inner race.

ST 899754112 Snap Ring Press, or equivalent.