Initial Inspection and Diagnostic Overview
Security System1. STARTER INTERRUPT RELAY
1. Disconnect connector of starter interrupt relay.
2. Connect battery to terminal No.1 and ground terminal No.2.
3. Check continuity between terminals as indicated in table.
2. HEADLIGHT ALARM RELAY
1. Disconnect connector of headlight alarm relay.
2. Connect battery to terminal No.1 and ground terminal No.2.
3. Check continuity between terminals as indicated in table.
3. ENGINE HOOD SWITCH
1. Disconnect connector of engine hood switch.
2. Check continuity between terminals when push rod is pushed in 1.5 mm (0.059 in) of its stroke.
4. KEY CYLINDER LOCK/UNLOCK SWITCH AND TAMPER SWITCH
Door Switch
1. Disconnect connector of door key cylinder switch.
2. Move switch by turning the key cylinder with ignition key and/or remove switch from key cylinder to check continuity between terminals as indicated in table.
Trunk Lid Switch (SEDAN)
1. Disconnect connector of trunk lid key cylinder switch.
2. Move switch by turning the key cylinder with ignition key and/or remove switch from key cylinder to check continuity between terminals as indicated in table.
Rear Gate Switch (WAGON)
1. Disconnect connector of rear gate key cylinder switch.
2. Move switch by turning the key cylinder with ignition key and check continuity between terminals as indicated in table.
5. DOOR LOCK/UNLOCK SWITCH
NOTE: The door lock/unlock switch is united with the power door lock actuator.
1. Disconnect connector of door lock/unlock switch.
Driver's Door:
Passenger's Door:
Rear Gate (Wagon):
2. Set switch to each position and check continuity between terminals as indicated in table.
6. DOOR SWITCH
NOTE: The door switch is combined with the door switch for room light.
7. TRUNK LID SWITCH (SEDAN)
Refer to trunk lid switch for inspection.
NOTE: The trunk lid switch is combined with the trunk room light switch.
8. REAR GATE SWITCH (WAGON)
Refer to rear gate switch for inspection.
NOTE: The rear gate switch is combined with the luggage room light switch.
9. SECURITY INDICATOR LIGHT
1. Remove security indicator light.
2. Check continuity between terminals of security indicator light.
3. If there is no continuity, the indicator light will be failured.
Terminals: No.2 - No.4
10. SECURITY CONTROL MODULE
Refer to security control module: "6. SECURITY SYSTEM" for inspection.