Diagnostic Procedure: Trunk (Sdn)/Rear Gate Switch (Wgn) Signal

Step 1 - 2:

I : DIAGNOSTICS PROCEDURE FOR TRUNK LID SWITCH (SEDAN) OR REAR GATE SWITCH (WAGON) SIGNAL

1. CHECK TRUNK LID SWITCH (SEDAN) OR REAR GATE SWITCH (WAGON) INPUT SIGNAL FOR SECURITY CONTROL MODULE.




1. Remove security control module without disconnecting connector.
2. Turn trunk lid switch (or rear gate switch) ON/OFF and measure voltage between security control module connector and body.

Connector & terminal / Specified voltage:
(B93) No.11 - Body / 10 V, or more (Lid or gate closed) / 1 V, max. (Lid or gate opened)

2. CHECK TRUNK LID SWITCH (SEDAN) OR REAR GATE SWITCH (WAGON).
Refer to trunk lid switch/rear gate switch for inspection.

NOTE: The trunk lid switch/rear gate switch is used for both trunk room light/luggage room light.