Sunroof / Moonroof: Testing and Inspection
Sunroof1. SUNROOF SWITCH
Set sunroof switch to each position and check continuity between terminals as indicated in table.
2. SUNROOF MOTOR
1. Apply battery voltage between 1-pin connector and body ground wire.
2. Make sure that sunroof motor moves when connecting terminals as described below:
- Connect between terminals No.3 and 4 (OPEN)
- Connect between terminals No.6 and 4 (CLOSE)
- Connect between terminals No.5 and 4 (TILT UP)
- Connect between terminals No.2 and 4 (TILT DOWN)
3. SUNROOF RELAY
Check continuity between terminals as indicated in table, when battery voltage is applied between terminals No.1 and No.3.