Removal

ABS Control Module and Hydraulic Control Unit [ABS 5.3i Type]

REMOVAL
1) Disconnect ground cable from battery.
2) Remove air intake duct from engine compartment to facilitate removal of ABSCM&H/U.
3) Use an air-gun to get rid of water around the ABSCM&H/U.

CAUTION: The contact will be insufficient if the terminal gets wet.





4) Pull on the lock of the ABSCM&H/U connector to remove it.
5) Disconnect connector from ABSCM&H/U.

CAUTION: Be careful not to let water or other foreign matter contact the ABSCM&H/C terminal.

6) Unlock cable clip.
7) Disconnect brake pipes from ABSCM&H/U.

CAUTION: Wrap brake pipes with vinyl bag to avoid spilling brake fluid on vehicle body.





8) Remove ABSCM&H/U from engine compartment.

CAUTION:
- ABSCM&H/U cannot be disassembled. Do not attempt to loosen bolts and nuts.
- Do not drop or bump ABSCM&H/U.
- Do not turn the ABSCM&H/U upside down or place it on its side.
- Be careful to prevent foreign particles from getting into ABSCM&H/U.
- Apply a coat of rust-preventive wax (Nippeco LT or GB) to bracket attaching bolt after tightening.
- Do not pull harness disconnecting harness connector.