TCS Warning Light Comes On When Starting Engine

TCS WARNING LIGHT INSPECTION
1. Turn ignition switch OFF.
2. Disconnect connector from ABS/TCS control module.





3. Measure resistance between ABS/TCS control module connector (P6) No. 3 and body. Resistance should be 1 M ohm.

DIAGNOSIS TERMINAL INSPECTION
1. Turn ignition switch OFF.





2. Measure resistance between diagnosis terminal and body. Resistance should be 0 ohms.

DIAGNOSIS CONNECTOR INSPECTION
1. Turn ignition switch OFF.
2. Disconnect connector from ABS/TCS control module.





3. Measure resistance between diagnosis connector (B82) No. 4 and body. Resistance should be 0 ohms.