ABS Only

CALLING UP A TROUBLE CODE





1. Take out ABS diagnosis connector from side of driver's seat heater unit.
2. Turn ignition switch OFF.
3. Connect ABS diagnosis connector terminal 6 only, to diagnosis terminal (B81 grounds). Either diagnostic terminal is a ground point.
4. Turn ignition switch ON.
5. ABS warning light is set in the diagnostic mode and blinks to identify trouble code.





6. After the start code (11) is shown, the trouble codes will be shown in order of the last information first.
These repeat for a maximum of 5 minutes.

NOTE: When there are no trouble codes in memory, only the start code (11) is shown.