Assembly
ASSEMBLYBrake And Clutch Pedal
1) Attach stop light switch, etc. to pedal bracket temporarily.
2) Clean inside of bores of clutch pedal and brake pedal, apply grease, and set bushings into bores.
3) Align bores of pedal bracket, clutch pedal and brake pedal, attach brake pedal return spring and clutch pedal effort reducing spring (vehicle with hill holder), and then install pedal bolt.
Tightening torque:
T2: 29 ± 7 Nm (3.0 ± 0.7 kg-m, 21.7 ± 5.1 ft-lb)
NOTE: Clean up inside of bushings and apply grease before installing spacer.
4) Set brake pedal position by adjusting position of stop light switch.
Pedal position: L
125.9 mm (4.96 in)
Tightening torque:
T1: 8 ± 2 Nm (0.8 ± 0.2 kg-m, 5.8 ± 1.4 ft-lb)
Accelerator Pedal
Clean and apply grease to spacer and inside bore of accelerator pedal. Install accelerator pedal onto pedal bracket.