Cruise Control: Service and Repair

REMOVAL AND INSTALLATION

1. CRUISE CONTROL MAIN SWITCH
1. Remove screws which secure meter visor.
2. Remove meter visor from instrument panel while disconnecting connectors.




3. Remove cruise control main switch from meter visor.

2. CRUISE CONTROL COMMAND SWITCH
1. Remove screw which secures horn pad to the base of steering wheel.
2. Remove horn pad from steering wheel while disconnecting connector.




3. Disconnect connector of cruise control command switch.
4. Remove screws which secure cruise control command switch to steering wheel, and then remove command switch.

WARNING: Refer to Supplemental Restrain System when removing or Installing the module from the airbag equipped model.

3. ACTUATOR

CAUTION:
- Be careful not to apply excessive load to the wire cable when adjusting and/or installing; otherwise, the actuator may be deformed or damaged.
- Do Dot bend cable sharply with a radius less than 100 mm (3.94 in); otherwise, cable may bend permanently, resulting in poor performance.
- When installing cable, be careful not to sharply bend or pinch the inner cable; otherwise, the cable may break.




1. Loosen nut which secures cruise control cable end to throttle cam, and then remove cable from engine throttle cam.
2. Remove clip bands from cruise control cable.




3. Remove nuts which secure actuator.
4. Remove actuator while disconnecting vacuum hose.

Tightening torque:
7.4 ± 1.5 N.m (0.75 ± 0.15 kg-m, 5.4 ± 1.1 ft-lb)

4. VACUUM PUMP AND VALVES




1. Disconnect connector from vacuum pump.
2. Remove bolts which secure vacuum pump.
3. Remove A/C receiver/drier bracket.
4. Remove vacuum pump while disconnecting vacuum hose.

Tightening torque:
7.4 ± 1.5 N.m (0.75 ± 0.15 kg-m, 5.4 ± 1.1 ft-lb)

5. STOP AND BRAKE SWITCH
Refer to removal and installation of stop and brake switch.

6. CLUTCH SWITCH (MT)
Refer to removal and installation of clutch switch.

7. INHIBITOR SWITCH (AT)
Refer to removal and installation of inhibitor switch.

8. CRUISE CONTROL MODULE




1. Follow the same preparatory procedures when removing door lock timer.
2. Remove nuts which secure cruise control module, and remove cruise control module from bracket while pulling right side lower end of instrument panel.

CAUTION: Be careful not to damage instrument panel while pulling its right side lower end.

3. Disconnect connector from cruise control module.
4. Installation is the reverse order of removal.