1. Piston Pin and Cylinder Block Connecting Bolt

1. PISTON PIN AND CYLINDER BLOCK CONNECTING BOLT
1) Remove service hole cover and service hole plugs using hexagon wrench (14 mm).





2) Rotate crankshaft to bring #1 and #2 pistons to bottom dead center position, then remove piston circlip through service hole of #1 and #2 cylinders.





3) Draw out piston pin from #1 and #2 pistons by using ST. ST 499097500 PISTON PIN REMOVER

CAUTION: Be careful not to confuse original combination of piston, piston pin and cylinder.

4) Similarly remove piston pins from #3 and #4 pistons by using ST.
5) Remove bolts which connect cylinder block on the side of #2 and #4 cylinders.
6) Back off bolts which connect cylinder block on the side of #1 and #3 cylinders two or three turns.