Horn: Service and Repair
Horn and Cigarette LighterREMOVAL AND INSTALLATION
1. HORN
1. Open the engine hood.
2. Disconnect connector of horn.
3. Remove the horn.
Tightening torque:
18 ± 5 N.m (1.8 ± 0.5 kg-m, 13.0 ± 3.6 ft-lb)
CAUTION: After installing horn, connect connector, fit firmly wiring harness to prevent from disconnecting due to vibration.
2. HORN SWITCH (HORN PAD)
1. Remove screw which secures horn switch (steering pad) to the base of steering wheel.
2. Remove horn switch (steering pad) from steering wheel while disconnecting connector.
3. CIGARETTE LIGHTER
1. Remove center panel from instrument panel.
2. Disconnect connector from cigarette lighter.
3. Turn illumination socket 450 counterclockwise and remove it.
4. Loosen nut, and then remove cigarette lighter body.
CAUTION:
- Align socket with cutout portion of instrument panel during installation.
- In case of replacing cigarette lighter, use genuine part only and always replace both plug and socket combination.