Rollover Valve: Service and Repair

ROLL OVER VALVE REMOVAL
1. Lift up the vehicle.





2. Remove roll over valve with bracket.
3. Disconnect hoses from roll over valve, and remove it from bracket.

INSPECTION





1. Connect hoses to roll over valve as shown.
2. While blowing through open end of hose, tilt valve at least 90° left and right from normal position.
3. Ensure that there is no air flow when hose is tilted greater than 90°.

INSTALLATION





Installation is in the reverse order of removal.

CAUTION:
- Do not install top side of valve down.
- Before installing bracket on body, securely fit concave part of bracket to hole in body.