Airbag Connector

AIRBAG CONNECTOR

The SRS airbag adopts a connector which has a double lock mechanism and coupling error detection mechanism for enhanced reliability. If coupling is incomplete, the airbag warning light comes on in the combination meter.




- Connector coupled to airbag control module
To disconnect the connector, press wire (1) of the airbag control module as illustrated until the green lever (2) tilts up. This unlocks the double lock, then you can pull off the connector while pressing tile connector lock.

To couple the connector, insert the three connectors until a "click" is heard, then push in the green lever (2) to apply the double lock.




- Connector between harnesses
To disconnect the connector, press lever (1) to pop green lever (2) out, this unlocks the double lock system. Then separate the connector by pulling both sides while holding the connector sections and pressing in lever (1).

To couple the connector, insert both connectors until a "click" is heard, then push in the green lever (2) until a "click" is heard, this applies the double lock.