Torque Converter Clutch Case Section

1. Wrap the axle shaft serration with vinyl tape
2. Remove the differential side retainer with ST 499787000 WRENCH ASSY or equivalent.

CAUTION: Hold the differential case assembly by hand to avoid damaging retainer mounting hole of the torque converter clutch case and speedometer gears.





3. Extract the axle shaft with ST1 and ST2.
ST1 499095500 Remover or equivalent.
ST2 499247300 Installer or equivalent.

CAUTION: Do not reuse the circlip.





4. Remove the differential case assembly

CAUTION:
- Remove the seal pipe if it is attached. (Reusing is not allowed.)
- Be careful not to damage the retainer mounting hole of the torque converter clutch case and the speedometer gears.





5. Remove the snap ring. Then remove the speedometer driven gear.





6. Remove vehicle speed sensor 2.
7. Tap out the speedometer shaft to the outside of the case, and remove the oil seal.