Brakes and Traction Control: Service and Repair: Adjustments
ADJUSTMENTSConfirm stopping and starting performances by activating hill holder on an uphill road of 30 or higher inclination.
(1) If vehicle does not stop;
Tighten adjusting nut of PHV cable.
(2) If vehicle does not start properly;
- Case A When hill holder is released later than engagement of clutch pedal (Engine tends to stall.):
Loosen adjusting nut gradually until smooth starting is enabled.
- Case B When hill holder is released earlier than engagement of clutch pedal (Vehicle slips down slightly.):
Tighten adjusting nut so that hill holder is released later than engagement of clutch pedal (status in Case A). Then make adjustment the same as in Case A.
NOTE: Whenever turning adjusting nut, prevent PHV cable from revolving as shown in Figure.