Disassembly

1. Remove right and left snap rings (1) from differential, and then remove two axle drive shafts (2).

NOTE: During reassembly, reinstall each axle drive shaft in the same place from which it was removed.

2. Loosen twelve bolts (3) and remove hypoid drive gear (4).





3. Drive out straight pin (5) from differential assembly toward hypoid driven gear, using Special Tool (ST).
ST 899904100 Remover, or equivalent





4. Pull out pinion shaft (6), and remove differential bevel pinion (7) and gear (8) and washer (9).





5. Remove roller bearing using ST.
ST 399527700 Puller Set, or equivalent