Restraint Systems

DIAGNOSIS:
- (AB9) and (AB10) are not connected properly.
- (AB2) and (AB7) are not connected properly.
- (AB3) and (AB8) are not connected properly.
- (AB6) is not connected properly to airbag control module

CAUTION: Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground cable and then wait at least 20 seconds.

5F1: DOUBLE LOCK INSPECTION FOR CONNECTORS (AB9) AND (AB10)




1. Remove front pillar lower trim (Passenger side).
2. Check double lock of connectors (AB9) and (AB10).

CHECK: Is there poor contact in double lock or connectors (AB9) and (AB10)?

YES: Repair poor contact in double lock of connectors (AB9) and (AB10).

NO: Go to step 5F2.

5F2: AIRBAG CONTROL MODULE DOUBLE LOCK INSPECTION AT CONNECTOR (AB6)




Check double lock of connector (AB6) connected to airbag control module.

CHECK: Is there poor contact in double lock or connector (AB6)?

YES: Repair poor contact in double lock of connector (AB6).

NO: Go to step 5F3.

5F3: DOUBLE LOCK INSPECTION FOR CONNECTORS (AB3) AND (AB8)




1. Remove lower cover panel.
2. Check double lock of connectors (AB3) and (AB8) below steering column.

CHECK: Is there poor contact in double lock or connectors (AB3) and (AB8)?

YES: Repair poor contact in double lock of connectors (AB3) and (AB8).

NO: Go to step 5F4.

5F4: ROLL CONNECTOR DOUBLE LOCK INSPECTION AT CONNECTORS (AB2) AND (AB7)




Remove driver's airbag module, and check double lock of connectors (AB2) and (AB7) at roll connector.

CHECK: Is there poor contact in double lock or connectors (AB2) and (AB7)?

YES: Repair poor contact in double lock at connectors (AB2) and (AB7).

NO: Replace airbag control module.