Test 8J9

Test 8J9:
1) Raise all four wheels of ground.
2) Turn ignition switch OFF.





3) Disconnect connector from ABS control module.
4) Remove band.
5) Remove cable clamp cover.
6) Remove screws securing connector cover.

CAUTION: Do not allow harness to catch on adjacent parts during installation.





7) Remove connector cover.

NOTE:
- To install, reverse above removal procedures.





- Align connector cover rib with connector hole before installation.

8) Connect connector to ABS control module.
9) Connect the oscilloscope to the ABS control module connector in accordance with trouble code.
10) Turn ignition switch ON.





11) Rotate wheels and measure voltage at specified frequency.

NOTE: When this inspection is completed, the ABS control module sometimes stores the trouble code 29.

Connector & terminal:
(F49) No. 14 (+) & No. 15 (-) (Front RH):
(F49) No. 49 (+) & No. 19 (-) (Front LH):
(F49) No. 18 (+) & No. 46 (-) (Rear RH):
(F49) No. 16 (+) & No. 17 (-) (Rear LH):
Specified voltage: 0.12 - 1 Volt (When it is 20 Hz.)
CHECK: Is oscilloscope pattern smooth. as shown in figure?
YES: Go to test 8J13.
NO: Go to test 8J10.