Inspection With Scan Tool
INSPECTION1. Check G sensor.
1) Turn ignition switch to OFF.
2) Connect scan tool connector to data link connector.
3) Turn scan tool into ABS mode.
4) Press F, 1 and 0 on the scan tool.
5) Read the scan tool display.
CHECK: Is the indicated reading 2.3 ± 0.2 Volts when the vehicle is in horizontal position?
YES: Go to step 2.
NO: Replace G sensor.
2. Check G sensor (forwards).
1) Remove console box.
2) Remove G sensor from vehicle. (Do not disconnect connector.)
3) Read the scan tool display.
CHECK: Is the indicated reading 3.9 ± 0.2 Volts when G sensor is inclined forwards to 90�?
YES: Go to step 3.
NO: Replace G sensor.
3. Check G sensor (backwards).
Read the scan tool display.
CHECK: Is the indicated reading 0.7 ± 0.2 Volts when G sensor is inclined backwards to 90�?
YES: G sensor is normal.
NO: Replace G sensor.