Front
REMOVAL1. Disconnect front ABS sensor connector located in engine compartment.
2. Remove bolts which secure sensor harness to strut.
3. Remove bolts which secure sensor harness to body.
4. Remove bolts which secure front ABS sensor to housing, and remove front ABS sensor.
CAUTION:
- Be careful not to damage pole piece located at tip of the sensor and teeth faces during removal.
- Do not pull sensor harness during removal.
5. Remove front disc brake caliper and disc rotor from housing after removing front tire.
6. Remove front drive shaft and housing and hub assembly.
Fig. 37 Tone Wheel & Hub Assembly:
7. Remove tone wheel while removing hub from housing and hub assembly.
CAUTION: Be careful not to damage teeth faces of tone wheel during removal.
INSTALLATION
1. Install tone wheel on hub, then install housing on hub assembly.
2. Temporarily install front ABS sensor on housing.
CAUTION: Be careful not to strike ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.
3. Install front drive shaft to hub spline.
4. Install front ABS sensor on strut and wheel apron bracket.
Tightening torque: 32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
5. Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire perimeter, tighten ABS sensor on housing to specified torque.
ABS sensor standard clearance: 0.9 - 1.4 mm (0.035 - 0.055 inch)
Tightening torque: 32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
CAUTION: Check the marks on the harness to make sure that no distortion exists. (RH: white, LH: yellow)
NOTE: If the clearance is outside specifications, readjust.